|
Post by threegirls on May 10, 2020 23:40:28 GMT
I just tried my Cameo 4 and part of the design was cut above the top grid lines. On my old, old Cameo I would change the material setting on the control panel. For the life of me, I can not figure out how to get the whole design to cut without the top part of the design being cut on the top section of the mat. I really hope this makes sense.
How do I get the whole design to cut on the actual cutting area of the mat?
|
|
|
Post by Basket1lady on May 12, 2020 13:03:07 GMT
It sounds like you have the “without mat” selected. I do that sometimes when cutting vinyl. Go in where it has you select the mat size and make sure that you are selecting “cut with mat” or something like that.
|
|
|
Post by threegirls on May 13, 2020 15:42:20 GMT
|
|