|
Post by Sandie on Nov 13, 2014 20:29:08 GMT
Not like a hook you would put in the ceiling, but one you would hook onto the center ring and shorten the chain by hanging it on the hook.
I have a hanging lamp and a chandelier, both of which are attached through the ceiling, as opposed to plugged in and then hung. Both have a center ring that the hanging chain is threaded through where the electrical cord comes out of the ceiling. Both need to be shortened temporarily (unless I like it and then it might become permanent). Since it is most likely temporary, I would rather not have to pay for an electrician until I see if I would like to change it permanently. I called 3 electricians but they said they couldn't give me an opinion but would be happy to come out and give me an estimate :/
If I hung a rubberized hook from that center ring, then hung the chain on it to shorten it, will that put undo stress on the center attachment and maybe pull it out of the ceiling? I know that the weight would be the same, of course, but does the length of the chain make a difference on how the weight is carried? I googled it but I guess I couldn't phrase it correctly as I could not find my answer.
Any help would be greatly appreciated!
|
|
Deleted
Posts: 0
Sept 7, 2024 12:59:14 GMT
|
Post by Deleted on Nov 13, 2014 20:42:00 GMT
I have used a carabiner clip before. I got one that matched the chain and haven't had any problems.
|
|
|
Post by SnowWhite on Nov 13, 2014 20:45:29 GMT
I have used a carabiner clip before. I got one that matched the chain and haven't had any problems. That's what I was thinking a carabiner or an S-hook from the hardware store would be fine.
|
|
freebird
Drama Llama
'cause I'm free as a bird now
Posts: 6,927
Jun 25, 2014 20:06:48 GMT
|
Post by freebird on Nov 13, 2014 20:47:10 GMT
You can pull all the weight up on your chain with an s hook, it will carry the same weight. I've seen them do something similar in restaurants before.
|
|
|
Post by Restless Spirit on Nov 13, 2014 20:48:40 GMT
We used zip ties (aka clear cable ties) to shorten the hanging light that was over our kitchen table. Shortly after we moved into our house we bought a pub height kitchen table and chairs so the fixture hung too low. We shortened it with a couple of clear zip ties. It stayed that way for 9 years because we totally forgot about it! We cut the ties when we moved.
We did the same thing in this house (same table) because we knew we were replacing the fixture and didn't want to go to the trouble of shortening the old fixture.
No problems that I know of.
|
|
|
Post by Sandie on Nov 13, 2014 20:49:03 GMT
Yay! I was so glad to read your posts! The hook I am going to use is an S hook ( actually pilfered from my hanging rack for pots and pans).
I was worried that they would come crashing down on guests...always a sign of a bad party haha
Thank you!
|
|
|
Post by wallyagain on Nov 13, 2014 20:49:41 GMT
Yes, the chandelier fixture in our dining room was a hazard, DH hit his head many times. So we used an S hook to shorten up the chain. It's been like that for many years.
|
|
Deleted
Posts: 0
Sept 7, 2024 12:59:14 GMT
|
Post by Deleted on Nov 13, 2014 20:52:39 GMT
I did this for a kitchen fixture with a giant paperclip. It was there for 12 years before we replaced it with our current fixture with no issues.
|
|