|
Post by flanz on Aug 11, 2015 17:42:11 GMT
.... I need to figure out how to set them up so that they will play continuously. I want some slides on the screen longer than others (lots ot read/ look at as opposed to some which are a single photo) and don't know how to do that or proceed from this point. This is for a presentation at church during a worship service and will be about 5 minutes long. Want to be able to hand it to the A/V volunteer all done and ready to go.
Is there a good tutorial on this stuff you are aware of? Is it a simple answer someone here might be able to provide?
Thanks in advance!
|
|
|
Post by JustCallMeMommy on Aug 11, 2015 17:54:03 GMT
There are a few ways to do this. I would go to the Transitions tab and over on the right, you can set a default duration, turn off Advance Slide On Mouse Click, and Apply to All. Then, you can adjust the duration on any other slide that needs to be a different duration.
ETA: To make it loop, you will go to Slide Show: Set Up Show and choose Loop Continuously. Make sure Advance Slides is set to use the timings.
|
|
|
Post by flanz on Aug 11, 2015 20:53:29 GMT
There are a few ways to do this. I would go to the Transitions tab and over on the right, you can set a default duration, turn off Advance Slide On Mouse Click, and Apply to All. Then, you can adjust the duration on any other slide that needs to be a different duration. ETA: To make it loop, you will go to Slide Show: Set Up Show and choose Loop Continuously. Make sure Advance Slides is set to use the timings. Thank you very much JustCallMeMommy! I will try that! I appreciate your help.
|
|
|
Post by flanz on Aug 11, 2015 20:54:07 GMT
There are a few ways to do this. I would go to the Transitions tab and over on the right, you can set a default duration, turn off Advance Slide On Mouse Click, and Apply to All. Then, you can adjust the duration on any other slide that needs to be a different duration. ETA: To make it loop, you will go to Slide Show: Set Up Show and choose Loop Continuously. Make sure Advance Slides is set to use the timings. One more question, if you don't mind. Once I do that step, can i still add and rearrange the order of the slides?
|
|
|
Post by JustCallMeMommy on Aug 11, 2015 21:45:10 GMT
Yes, you can. Just be sure to check the timing settings on the new slides.
|
|